|
|
Landing Gear |
|||||||||||||||||||||||||||
Page 5 |
|||||||||||||||||||||||||||
These are the start of my main gear brackets. They are 1/4" x 3" 4130 plate heated and bent to a 90 degree angle. |
. |
|
|
||||||||||||||||||||||||
I welded 1/8" 4130 plate as sides to it and a 2" wide stiffener across the third side of the angle. There were five 3/8" holes drilled into the bracket. One at the top spar cap, Two at the bottom spar cap, and two on the bottom of the "L" to fit the radius blocks that the main gear actually bolt to. |
|
||||||||||||||||||||||||||
The brackets were mounted to the rear face of the main spar with three 3/8" bolts. |
|
||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||
